How To Align Walls With Plasterboard Video Tutorials

2023 Author: Philip Bishop | [email protected]. Last modified: 2023-08-25 07:54

• Varieties of work
• Plasterboard wall alignment video

This method has a number of undoubted advantages over the others - this is the high speed of the work itself, the ability to install additional sound and heat insulation, there is no need to remove the old coating, and leveling the walls with plasterboard with video instructions becomes even easier. Home renovation site continues a series of articles on drywall.

Varieties of work

There are two main methods of leveling the walls of the gypsum board - without mounting the frame and with mounting. In the first case, a simple pasting of the walls with sheets of drywall is made (it is used only for smooth, solid walls). The second method is used when there is a danger of subsidence or deformation of the walls.

We start with the markup. First, draw parallel lines on the ceiling and on the floor using a level. This is the markup for the starting wireframe. Further, along strictly vertical lines on the walls, every 60 cm or 40 cm, we outline the places of attachment of the suspensions for the bearing profile. This distance is due to the fact that the standard width of the drywall sheet is 120 cm. Thus, the edges of the sheet will lie approximately in the middle of the bearing guides.

It is necessary to determine in advance the places where the wiring exits, the need to use mineral wool or cork sheets for heat and noise insulation. Plasterboard wall alignment proceeds to the next stage.

We proceed directly to the installation. We fasten sections of a galvanized metal profile to the floor and ceiling with self-tapping screws - the so-called starting frame. In order to achieve reliable fixation, it is required to use 3 - 4 self-tapping screws per meter of profile. Then we attach metal hangers to the wall with hammer-in dowels. We insert the supporting rail into the starting frame, while the upper edge of the rail should not rigidly abut against the upper profile. We consistently fasten the carriers to the starting frame and suspensions with self-tapping screws for metal. Insert the next guide. It is recommended to put small wooden blocks under the guides at the joints with the hangers to make the whole structure more rigid. Our tips for working with profiles and sheets will help you.

We begin to mount the drywall sheets. Previously, it is worth treating the sheets with a special water-repellent primer. Next, we fasten the sheets to the frame with self-tapping screws for drywall, based on the calculation that one self-tapping screw goes by 30 cm. After installing the last sheet, we close the seams with a serpentine and putty. After drying, it is required to sand the unevenness with sandpaper. Now we cut the holes for the sockets and stretch the cable. We make the final putty and sanding of the entire surface of the gypsum board. We take into account that any kind of do-it-yourself wall putty is suitable for wallpaper, only finishing is suitable for paint, and it is not needed at all for tiles.

Plasterboard wall alignment video

Video:

Video: