Methods For Self-painting A Cast-iron Bath With Epoxy Enamel

Table of contents:

Video: Methods For Self-painting A Cast-iron Bath With Epoxy Enamel

Video: Methods For Self-painting A Cast-iron Bath With Epoxy Enamel
Video: How to Paint a Bath 2023, September
Methods For Self-painting A Cast-iron Bath With Epoxy Enamel
Methods For Self-painting A Cast-iron Bath With Epoxy Enamel
Anonim
  • What are the stages and methods of painting a font Main nuances and features of this process
  • Painting tools and accessories
  • Features of the preparation of epoxy enamel
  • Can I paint my bathtub with acrylic paint myself?

For those planning to renovate the bathroom, the issue of renovating the bathtub is an acute issue. But even a cosmetic repair of a product requires certain skills and knowledge.

What are the stages and methods of painting a font Main nuances and features of this process

Firstly, it should be borne in mind that the bath is in a room of high humidity, almost every day it "comes into contact" with water, which means that dyes should be selected according to these characteristics, and not just because you liked the color. The mixture must be resistant to moisture and have increased adhesion. Reliably "stick" to the surface, so that after a certain time the paint does not peel off.

Experts advise buying three-component formulations, mainly from manufacturers such as Dulux, Tikkurila, Jobi. They contain a primer of pale, semi-matte colors.

Before you paint the bath with your own hands, you need to prepare protective equipment.

  • Respirator with absorber cartridge, you can use civil or military gas masks.
  • Oilcloth apron and rubber gloves. Latex two-layer will do, but then you need to cook at least 2-3 pairs.

Attention: it is necessary to perform colorful work with the windows wide open, with good ventilation, which means that it is not advisable to paint the bath with your own hands in winter, at 20 degrees of frost. It will be cold for all households!

Painting tools and accessories

  1. Natural brush, 90 mm.
  2. Sanding pad and rubber-based Durex disc.
  3. Painter's knife to remove lint from the brush.
  4. 0.5 l. acetone or solvent No. 646.
  5. Microfiber or sulphite clean towel for wiping respirator glasses.

What paint can you paint your bathtub with? Choosing a material

The most common paint is epoxy enamel, which has been used in construction for over 20 years. It serves for a very long time, but it also requires technically accurate execution of all stages of its application.

Acrylic for restoration is used relatively recently, but in terms of resistance it is practically not inferior to epoxy. It is easily applied, but it is an order of magnitude higher than the previous material.

For a beginner and far from a non-professional in the implementation of painting work, it is better to use acrylic.

The first stage of painting a bathroom with your own hands is preparation.

Consists of four elements:

  • cleansing;
  • grinding;
  • degreasing;
  • covering tiles with tape.

The bath is thoroughly cleaned from various contaminants, for this you need to pour oxalic acid, Pemolux or another active detergent on the bottom. Soak for 15-20 minutes and then rinse. Now we start abrasive processing. Remove the drain plugs and smooth the surface with an electric drill with Durex. We check the result with an LED flashlight, there should be no gleaming spots, as well as traces of rust and streaks.

Before degreasing, remove all dust with a vacuum cleaner, wipe the drain holes with a cloth moistened with solvent. Now, using gloves and an apron, pour 0.5 Sanox, Pemolux into the bathroom and rub it with a sponge over the entire surface of the product in an even layer. You can rest for an hour.

Attention: degreasing should be carried out during the grinding process in order to better slip the grinding wheel. For these purposes, ordinary soda can also be used, which is washed off with hot water and the surface is dried dry.

Next, we rinse the bath from detergents, ideally this should be done 1-2 times. Take a full bath and add 0.5 bottles of acid detergent.

After thorough rinsing, dry the surface with a construction hairdryer. We remove the strapping with a drain and proceed to painting the bath with enamel with our own hands.

Features of the preparation of epoxy enamel

It is necessary to start mixing all the components after the completion of the preparatory work, the mixture is suitable for 30-45 minutes after preparation.

A little solvent can be added to the composition, which will improve the flexibility of the property on the material. The required amount of hardener is used depending on the volume of the base. The ratio of all components can be read on the product packaging.

Note: measure the base in 250 ml portions and add one part of the hardener accordingly. Stir the mixture thoroughly.

We paint the bath with our own hands, the brush is abundantly lubricated with the composition and rubbed over the surface. Do not touch the painted area with your hands. If fibers from the brush appear, then they should be immediately removed with tweezers or a gypsy needle.

After the first application, we wait 15 minutes and again do all the work, from the same place and in the same direction. At the end of the procedure, the bath is closed for 2 days, the more, the better the painted surface will serve.

How to properly paint your bathtub to avoid dripping and sagging? Their formations should be carefully controlled and, if they occur, smeared with a brush upwards.

A possible variant of the restoration of an old bath, an acrylic insert or as it is also called "bath in a bath", is an insert that covers the entire surface of the old container.

Can I paint my bathtub with acrylic paint myself?

Image
Image
Bath painting tools
Bath painting tools
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

To paint a cast-iron bath inside, you need to stock up on a short-nap roller and buy the desired liquid. It is necessary to paint with a narrowing elongated spiral from the edges to the drain, you need to carefully monitor so that bubbles do not appear. If they occur, they should be pierced with a brush. It is necessary to apply another layer after the first one in an hour.

Acrylic paint Tub & Tile spreads well, but has a specific strong odor, use in a room with good ventilation. Has a long time to work.

Here's how to paint an old bathtub with your own hands, the finished surface, with proper paint application, will serve the owners for more than 10 years. It also effectively removes traces of rust, dents and chips.

Carefully study the instructions for painting the bathtub and please your loved ones with a snow-white "masterpiece" in your performance!

Recommended:

Interesting Articles
Features Of The Manufacture Of Modern Wooden Windows
Read More

Features Of The Manufacture Of Modern Wooden Windows

Modern wooden windows are in no way inferior to plastic ones. Description of the features of double-glazed windows of wooden windows and their advantages. What are the double-glazed windows for wooden windows? Is the structure sealed?

What Are The Disadvantages When Using A Semi-dry Screed
Read More

What Are The Disadvantages When Using A Semi-dry Screed

Negative qualities of floor devices using a semi-dry screed, the ability to eliminate the resulting manifestations from the negative side, careful adherence to technology

How To Choose A Good Manual Jigsaw, Which Is Better: Bosch Or Makita
Read More

How To Choose A Good Manual Jigsaw, Which Is Better: Bosch Or Makita

Recommendations when choosing a jigsaw. Description of basic and additional functions. Review analysis of jigsaws, detailed description of their technical characteristics and recommendations for use