Aligning Walls With Plaster On Beacons Video - Aligning The Wall With Your Own Hands

2023 Author: Philip Bishop | [email protected]. Last modified: 2023-08-25 07:54

• Do-it-yourself wall alignment with plaster
• Aligning walls with plaster on beacons video

DIY apartment renovation video - leveling the walls with plaster.

Before carrying out work, preparation of the base is required. At the same time, wallpaper is removed from the walls, cleaned of old loose plaster, paint, etc. Do-it-yourself work should be done carefully so as not to damage the electrical wiring, it is better to turn off the power supply of the room. See also the article about leveling the walls with drywall video and photo instructions are attached.

Do-it-yourself wall alignment with plaster

The cleaned surface must be primed. It is most convenient to apply the primer with a roller. If the surface absorbs the vagu well, then two coats of primer are applied. Lighthouses are installed only after the soil is completely dry. A nail is hammered into the upper corner of the wall, to which a cord (thread) with a load is tied, a plumb line is obtained. It is necessary to wait until the plumb line stops swinging. Then another nail is driven into the base of the wall so that its head is in line with the plumb line. We carry out a similar operation on the other side of the wall. After that, the lighthouse cord is pulled from nail to nail diagonally. A rule or an even rail is attached to the heads of the nails, checked with a level, after which the entire space between the rule and the wall should be filled with building mixture. We get a flat beacon line. The distance between the beacons is determined by the length of the tool that will be used to plaster the surface.

After the lighthouses have dried, you can start leveling the walls with plaster on the lighthouses with video instructions. Gypsum building mixtures are best used in residential premises, cement - in damp (kitchen, bathroom). The building mixture is poured into a large container and mixed with water. Mixed with a drill with a special nozzle. The resulting mixture should not be very thin or too thick. For better adhesion of the mixture to the wall, it is advisable to moisten the surface with water. A building mixture is poured onto the moistened wall with a small spatula. When the walls are leveled with plaster along the beacons, the mixture is thrown in such a way as to cover all cracks, potholes, crevices and its level should protrude 3 mm beyond the beacons. Before the mixture dries, it must be leveled. For this, a broad rule is used,moving it along the neighboring lighthouses from the bottom up. If the mixture is not enough, it must be thrown in, or carefully applied with a spatula. After finishing work on one site, they move on to the next, so the entire wall is plastered. The plastered surface after it dries is rough and serves as the basis for puttying. Small defects on the wall (up to 15 mm) can be removed with putty. After the putty has dried, you can sand the surface with sandpaper. Now watch a video lesson on the website repairing an apartment with your own hands, based on the materials of the "World of Repair" program. Small defects on the wall (up to 15 mm) can be removed with putty. After the putty has dried, you can sand the surface with sandpaper. Now watch a video lesson on the website repairing an apartment with your own hands, based on the materials of the "World of Repair" program. Small defects on the wall (up to 15 mm) can be removed with putty. After the putty has dried, you can sand the surface with sandpaper. Now watch a video lesson on the website repairing an apartment with your own hands, based on the materials of the "World of Repair" program.

Aligning walls with plaster on beacons video

Another video tutorial